Solar Installation Training Program

  1. Basic Electrical & Electronics components
  • Voltage, Current, Power, Energy
  • Basic RLC (Resistor, Capacitors, Inductors)
  • Transistor
  • Diode
  • IC(555,op-amp,regulater)
  • SCR
  • Sensors (LDR, reed switch, UV, Temp sensors)
  • Relay & Contactors
  • Types of RLC & Contactor
  • MCB/MCCB
  • Protection Circuits
  • Earthing – Grounding

      2.Cables and wires

  • Introduction Wires & Cables
  • Types of wires & cables,
  • Insulating materials,
  • Standard of wire gauge,
  • Specification of wires & cables,
  • Colour coding,
  • Precautions in using cables,
  • Wire ferrules, continuity testing.
  • Cabling and wiring accessories
  • Cable wire lugs, cable drum, cable trays
  • Cable Trenching
  • Selection of AC-DC cable or wire
  1. Hands-on Practice
  • Design 12v Regulated power supply on bread board. (AC to DC)
  • Sensors interface using 555(LDR,reed switch,UV,temp sensor)
  • Voltage divider circuits
  • Logic gate using transistors
  • Single phase Motor starter circuit using RLC
  • Three phase Motor starter circuit using Contactor
  • Solar charger controller circuit
  • Solar Inverter circuit
  • Solar mobile charger
  • Automatic Solar street Light
  1. Renewable energy (Thermal, Wind, Solar)
  • Definition of renewable energy
  • Advantage and disadvantage
  • Industrial application
  • Principal & Working
  • Future scope
  • Difference between all
  1. Solar energy
  • Definition of solar energy
  • Frequency spectrum of solar energy
  • Availability of solar energy on earth
  • Advantage and disadvantage of solar energy
  • Temperature, irradiation, Humidity
  • Insulator, Conductor, Semiconductor
  1. Solar PV system
  • Definition of solar PV system
  • Block diagram of solar PV system
  • Application of solar PV system
  • Advantage and disadvantage
  • Challenges in solar PV system
  • Thermal solar systems
  • Solar PV systems
  1. Solar PV panel
  • Definition of Solar Panels
  • Photovoltaic principal
  • Parts of panel
  • Types of PV panels
  • Application of solar PV panels
  • Technical Specifications of PV panel
  • Direction of PV panels
  • Tilt & Azimuth angle of panel
  • Manufacturing process of panels
  • Series & parallel connection of panels
  • Bypass diode & Blocking diode
  • Structures base of panels
  • Maintenance of Panels
  1. Solar charger controller
  • Definition of solar charger controller
  • Types of charger controller
  • PWM & MPPT
  • Block diagram of charger
  • Application of solar charger
  • Technical Specifications of charger
  • Installed Location of charger
  • Wring of charger
  • Maintenance of solar charger controller
  1. Battery
  • Definition of battery
  • Types of battery
  • Primary & Secondary
  • Block diagram of battery
  • Application of solar battery
  • Technical Specifications of battery
  • Charging & discharging time of battery
  • Backup time of battery
  • Installed Location of battery
  • Wring of battery
  • Manufacturing process of battery
  • Series & parallel connection of battery
  • Maintenance of batteries
  • Battery banks
  1. Solar Inverter
  • Definition of inverter
  • Types of inverter
  • Block diagram of inverter
  • Application of solar inverter
  • Technical Specifications of inverter
  • Installed Location of inverter
  • Wring of inverter
  • Maintenance of solar inverter
  • Calculation of inverter
  1. Solar AC-DC Load
  • Load calculation
  • Load factor
  • Safety & Derating factor
  • Technical Specifications Load
  • AC-DC Energy meter
  • Net meter
  1. Solar PV system installation
  • Site Survey
  • Reading of site Layout
  • Civil & Mechanical Work
  • Panel structure installation
  • Panel installation with STC condition
  • Combiner, Junction & Distribution box
  • Technical Specifications of cables
  • Batteries installation
  • Inverter installation
  • AC-DC Energy meter installation
  • Net meter installation
  1. Maintenance of Solar PV system
  • How to fill checklist
  • Solar panels maintenance
  • Maintenance of battery
  • Maintenance of inverter
  • Maintenance of Combiner, Junction & Distribution box
  • AC-DC Energy meter maintenance
  • How to read different meter readings
  1. Solar Protection & Electrical testing tools
  • Compass and GPS
  • Multimeter
  • Ammeter
  • Voltmeter
  • Clap meter
  • Incline meter
  • PH meter
  • Crimp tool
  • Installation protection tools
  • Reflating jackets, noise mask, goggles, gloves etc.
  • Civil work’s tools
  • Hammer, chisel, bob, Line Dori, hand saw water level etc.
  • Spanner, Pliers, wire cutters, Cable cutters etc.
  1. Calculation of Solar PV system
  • OFF grid or Rooftop solar PV system calculation step by step
  • ON grid or Grid-connected PV system calculation step by step
  • Solar power plant setup calculations
  • Commercial calculation of solar PV system
  1. Government schemes & subsidy policies
  • OFF grid or Rooftop solar PV system calculation step by step
  • ON grid or Grid-connected PV system calculation step by step
  • Solar power plant setup calculations
  • Commercial calculation of solar PV system
  • Future scope of solar in India
  • Companies of solar in India
  • Startup in solar area
  1. Automation in Solar system

PLC (Programmable logic controller)

Introduction to automation

  • Introduction of a Control System
  • RLC Controller, PID Controller, PLC Controller
  • History & Need of Industrial Automation
  • Application of Industrial Automation
  • Components of Automation
  • Hardware & Software of Automation

PLC Hardware Specification

  • What is PLC & Type of PLC
  • Hardware & Architecture of PLC
  • Application and Advantage of PLCs
  • Sourcing and Sinking concept
  • Programming Language of a PLC
  • Data files in PLC Programming
  • Description of a Logic Gates
  • PLC Programming on Simulator
  • Communication between PLC & PC
  • Wiring of PLC (Inputs & Outputs)
  • Monitoring programs & Uploading, Downloading
  • Introduction of Instructions
  • Introduction to Ladder Programming

Programming of PLC (ladder logic)

  • How to use Gates, Relay Logic in ladder logic
  • Addressing of Inputs/Outputs & Memory bit
  • Math’s Instruction ADD, SUB, MUL, DIV etc.
  • Logical Gates AND, ANI, OR, ORI, EXOR, NOT etc.
  • MOV, SET, RST, CMP, INC, DEC, MVM, BSR, BSL etc.
  • How to Programming using Timer & Counter
  • SQC, SQL etc.

Advance instruction in PLC

  • Jump and label instruction.
  • SBR and JSR instruction.
  • What is Forcing of I/O
  • Monitoring & Modifying Data table values
  • Programming on real-time applications
  • How to troubleshoot & Fault detection in PLC
  • Interfacing many type sensors with PLC
  • Interfacing with RLC for switching
  • PLC & Excel communication

SCADA (Supervisor control & data acquisition)

  • Introduction to SCADA Software
  • How to Create new SCADA Project
  • Industrial SCADA Designing
  • What is Tag & how to use
  • Dynamic Process Mimic
  • Real-Time & Historical Trend
  • Various type of related properties
  • Summary & Historical Alarms
  • How to create Alarms & Event
  • Security and Recipe Management
  • How to use properties like Sizing, Blinking, Filling, Analog Entry, Movement of Objects, Visibility etc.
  • What is DDE Communication
  • Scripts like Window, Key, Condition & Application
  • PLC – SCADA communication
  1. Multiple Application of Solar
  • Solar PV rooftop system
  • Solar tower
  • CSP based System
  • Solar Water heater
  • Solar street light
  • Solar park
  • Solar Car & Solar Airplane
  • Solar cooker
  • Solar thermal based power plant
  • Solar tracking system
  • Solar PV based power plant
  • Solar mobile charger
  • Solar based DC fan
  • Solar based water pump